Druckschrift 
The London Dispensatory
Entstehung
Seite
113
URN (Seite)
  
Einzelbild herunterladen
 

part r.

Pharmaceutical Opkratiovs.

113

already applied, although^ stream of vapour may be burstingthrough at the time. 1

c. Earthy Lutes are intended for operations which require ahigh temperature. The following are the best of this class.1. Mix burnt gypsum, in powder, with water to the con-sistence of a thick cream, and apply it immediately. Thisforms a lute which sets as soon as it is applied, and isfirm; but a slight blow will easily crack it.

2, Dissolve one ounce of borax in half a pint of boilingwater, and add as much slacked lime as will make apaste. By using a smaller portion of lime, this lute formsan excellent glazing for earthen-ware retorts, over whichit should be spread with a brush; but when dry, a coatingof slacked lime and linseed oil, beaten till the mixture isplastic, should be laid over the whole of the lute.

3. A very valuable fire lute may be made of about one partof glass of borax, five parts of brick-dust, and five partsclay, finely powdered together, and mixed with a littlewater when used.

4s The same composition which has been already describedas a proper coating for the inside of furnaces, is also anexcellent earthy lute.

5. Six parts of clay, and one of iron filings formed into apaste by means of linseed oil, form an excellent cementfor stopping cracks in iron retorts or boilers.

If the beak of a retort be too small to fit accurately to theneck of a receiver, the vacancy should be filled up, by intro-ducing short pieces of soft wood or of cork; and if the dispro-portion be very considerable, a cork must be fitted to the neckof the receiver, and a circular hole made in it sufficient toadmit the beak of the retort. The curved tube of a Woulfe'sapparatus, when not fitted accurately by grinding, may be alsofixed by means of corks. After the parts are th us firmly joined,the luting must be neatly and closely applied over the junc-tures; and the whole covered with slips of wet bladder, or withlinen spread with one or other of the above described cements.The application of the lutes, although apparently very simple,yet requires some management, lest the luting of one junctureshould disturb another already luted, which is apt to happenwhen applying the fillets and ligatures. When an operator,therefore, is not pressed for time, he-should always allow theluting of one joint to dry before he applies luting to another jindeed, it is preferable not to apply the fillets and ligatures,until after the luting has been applied to all the joints; and isnearly hard.

Aikin's Dictionary of Chemistry.I